Advanced-elements AE1009 Bedienungsanleitung PDF herunterladen (Seite 13)

AdvancedFrame Expedition™ Inatable Kayak Owner’s Manual

Follow these steps for removing excess water.

1. Unzip the 2 zippers that run down the center of the kayak.

2. Remove the gray fabric tube and cover, along with the inatable oor, separating it

from the outer cover. In order to completely separate these parts, it is necessary to

unscrew the locking nut on the spring valve.

3. Use a sponge or towel and wipe up any excess water in the outer cover.

4. Wipe o the oor (top and boom)

5. If there is sand or gravel in the kayak, you can hose out the cover and then wipe it

down with a towel.

6. Most of the time you can just pull out the inatable oor and wipe out the inside of the

kayak absorbing most of the water, then pack it up.

6. REPAIRS

All kayaks come with a repair kit that includes glue and several patches. This should remain

with the kayak in the event that you may need it. If service is required for your kayak, please call

866-262-9076 for assistance.

6.1 Repairing Small Punctures and Cuts

1. Cut a rounded patch at least ¼” or ½” larger than the hole or cut.

2. Clean the area where the patch will be placed with water and/or mild soap.

3. Make sure all surfaces are dry.

4. In a well ventilated area, spread a thin layer of glue on both the patch and on the

damaged area. Let it sit for three to ve minutes or until tacky.

6.2 Repairing Pinholes

1. Inate the PVC tube. Locate the pinhole by sponging soapy water over the tube until

you see air bubbles. Mark the location of the pinhole.

2. Deate the tube and dry the aected area. Apply a drop of glue to the pinhole

3. Allow glue to dry completely.

4. Do not inate the kayak for at least twelve hours.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Advanced-elements AE1009 Bedienungsanleitung Seite 13