Advanced Elements AF-4500s Betriebsanweisung PDF herunterladen (Seite 12)

INTRODUCTION

Advanced Flight Systems Inc. manufactures three different size EFIS and Engine Monitor systems. The AF-3400 uses a

6.5” display and the AF-3500 and AF-4500 use an 8.4” display. The new “s” CPU systems utilize our new high speed

CPU and support Synthetic Vision. The systems can be purchased as an EFIS only “EF”, Engine Monitor only “EM”, Multi

Function Display “MFD”, or as a single screen with both EFIS and Engine Monitor boards installed “EE”. Multiple systems

can be easily connected to share all data between screens. Install an EFIS “EF” and an Engine Monitor “EM” screen and

you will have the ability to display flight and engine instruments on both screens. Our EFIS Systems utilize

a Crossbow AHRS which is an AFS customized version of the certified Crossbow AHRS500.

WARNING

It is possible for any instrument to fail and display inaccurate readings. Therefore, you must be able to recognize an

instrument failure and you must be proficient in operating your aircraft safely in spite of an instrument failure. If you do not

have this knowledge, contact the FAA or a local flight instructor for training. The ability for this product to detect a problem is directly

related to the pilot’s ability to program proper limits and the pilot’s interpretation and observation skills. The pilot must understand the

operation of this product before flying the aircraft. Do not allow anyone to operate the aircraft that does not know the operation of this

product. A copy of this manual must be kept in the aircraft at all times.

The AF-3400/3500/4500 will automatically turn on any time power is applied to the unit.

NOTE: The system is designed to remove a gauge needle from the screen if a transducer is disconnected.

Each gauge can have an upper and lower caution and warning limit. If a gauge is in the caution area the needle and value

will turn yellow. If a gauge is in the warning area the needle and value will turn red.

If the engine RPM is greater than 500rpm and a gauge is in the warning area the gauge name will be displayed over button

1 in red and an audible warning will generated. For example if the oil pressure is low you should hear “Check Oil

Pressure”, this will repeat every 5 seconds until the gauge is no longer in the warning area or you press button 1 to

acknowledge the error and stop the audible warning for that gauge.

The system will give the audible warning “Check Fuel Computer” on startup if the fuel computer’s gallons remaining value

does not match the fuel tanks level. This feature (if turned on in Instrument Calibration) should warn you if you have added

fuel and forget to adjust the fuel computer. The number of gallons that will generate an error is adjusted in Instrument

Calibrate. Since the fuel levels are NOT accurate when the tanks are near full this value is doubled when the tanks show

full.

See Instrument Calibration for directions on setting the upper and lower caution and warning limits.

SD Card Slot

SD Card ICON

[Left Knob/Button] [Button1] [Button2] [Button3] [Button4] [Button5] [Right Knob/Button]

(AF-4500 Only) (Joystick AF-4500 Only

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 128 129

Keine Kommentare

Advanced Elements AF-4500s Betriebsanweisung Seite 12